Stock Tag FAQ

Below is a list of frequently asked questions in regards to stock tags:

How to remove a stock label from the roll

When removing the pieces of a stock tag, remove each section from the top left corner and move diagonally down to the right. This is to avoid any tearing or ripping of the tags that may occur. See the diagram below:

My labels are opening or not sticking properly

If you find that any tags are opening, just make sure that when you stick the stock tags together the tail of the ring tag does not pass over the centre perforation. This doubling over of the tail will still cause the tag to open regardless of the adhesion.

If you need a shorter tail, cut the tail to the desired length before sticking the tag together.

Note: The tail should be placed no more than 2mm before the centre perforation line. See the diagram below: